Wednesday 13 April 2016

MTF Mapper vs Imatest vs Quick MTF

I recently noticed that Quick MTF now has an automated region-of-interest (ROI) detection function. This allows me (in theory) to perform the same type of automated testing that I applied to MTF Mapper and Imatest. Now would be a good time to read the Imatest comparison post to familiarise yourself with my testing procedure.

Anyhow, the automatic ROI functionality in Quick MTF is almost able to work with the simulated Imatest charts I produced with mtf_generate_rectangle. I had to manually adjust about half of the ROIs to ensure that Quick MTF was using as much of each edge as possible, i.e., similar ROIs to what Imatest and MTF Mapper used. Since the edge locations remain the same across all the test images, I used the "open with the same ROI" option to keep the experiment as fair as possible.

I also discovered that QuickMTF's "trial" limit of 40 tests can be bypassed with relatively little fuss (Oleg, if you are reading this, I promise not to share the secret).

Lastly, note that I performed these tests using the "ISO 12233" mode of Quick MTF. The default settings produces much smoother plots, but these are severely biased, i.e., they report MTF50 values that are much too low. To illustrate: the default settings produce a 95th percentile relative error of 13% when measured using images with an expected MTF50 of 0.25 c/p; switching to ISO 12233 mode reduces the error to only 5%. As expected, the standard deviation of MTF50 error is lower in the default mode, but I maintain that bias and variance should both be managed well.

The results


Figure 1: Quick MTF MTF50 relative error boxplot
Figure 1 illustrates the relative MTF50 error boxplot, calculated as 100*(measured_mtf50 - expected_mtf50)/expected_mtf50. Firstly, Quick MTF should be commended for its unbiased performance between expected MTF50 values of 0.1 and 0.4 cycles/pixel; the median error is exactly zero. Unfortunately, a strong bias appears after 0.4 c/p, which is consistent with some (light) smoothing of the ESF. The boxes, and especially the whiskers, are a bit wide, which is more readily seen in Figure 2.

Figure 2: Standard deviation of relative MTF50 error
Things go a bit pear shaped when we look at the standard deviation of the relative MTF50 error. If we consider the "usable" range of 0.08 to 0.5 c/p, then Quick MTF contains the standard deviation below 3.5%, which is not bad, but Imatest and MTF Mapper perform a bit better here. A more useful (and my preferred) measure is the 95th percentile of relative MTF50 error magnitude, as illustrated in Figure 3.
Figure 3: 95th percentile of relative MTF50 error magnitude

The values in Figure 3 have a natural interpretation: the magnitude of the error will remain below the indicated value in about 95% of the edges measured with each tool. This measure combines the effects of bias (Figure 1) and variance (Figure 2) in one convenient value. Consider again the "usable" range of 0.08 to 0.5 c/p: Quick MTF only manages to keep the error below about 9% across the range. It does quite a bit better in the centre of the range, almost matching Imatest at 0.2 c/p.

Conclusion

The Imatest results were not based on the latest version; I do not have an Imatest license, and my trial has expired, so it will take a fair bit of effort to refresh the Imatest results. The Quick MTF 2.09 results are current, though.
Based on these versions, it would appear that MTF Mapper still produces competitive results. And you cannot beat MTF Mapper's price.